My Guides

Guides I've Contributed To

My Favorite Guides

Completed Guides

Notes

  • Build a Mintronics: MintDuino

    Step 16 (Take a look at the second image for placement)

    "Next, add the 100nF capacitor (marked 104 on one side and K1K on the other) from "c25" to b23". It is not polarized, so inserted either way is fine."

  • TV-B-Gone Kit

    Can you send some pictures of the board?

  • TV-B-Gone Kit

    You can download the firmware here -- http://www.ladyada.net/make/tvbgone/down...

  • Dispatchatron

    I really like this project...can you share more details about the PHP/Processing/AppleScript/BS2 code?

  • Small Amp

    That should be GND.

  • TV-B-Gone Kit

    Davey - It's an ATtiny85V-10-PU

  • Build a Mintronics: MintDuino

    The FTDI friend gets plugged in so the "black" or GND of the FTDI is towards the bottom of the board (30b). You can see the wire that jumps to ground.

    In the Arduino IDE select the proper com port for the FTDI (usually the first one listed, but no always), followed by a board type of "Arduino Duemilanove w/ATmega328"

    More tutorials coming soon! (I just finished reading one and it's great)

  • Build a Mintronics: MintDuino

    I added the parts list to the comment above, and will add them to the Make: Projects page soon. Thanks!

  • Build a Mintronics: MintDuino

    It is pin 13 of the "Arduino", which uses a different pin layout from the ATMega. It's pin 19 of the ATMega. I added a PDF of the pin layouts for clarification.

  • Build a Mintronics: MintDuino

    (1) ATmega328P (with Arduino bootloader)

    (1) Mint Tin

    (1) 1/2 size breadboard

    (1) 7805 Voltage regulator

    (1) 5mm LED Green

    (1) 5mm LED Red

    (2) 220 Ohm resistors

    (1) 10k Ohm resistor

    (2) 10 uF capacitors

    (1) .1uF capacitor

    (1) 16 MHz clock crystal

    (2) 22 pF capacitors

    (1) 100nF capacitor

    (1) Momentary normally open button

    (1) 6-pin male header

    (1) 9V battery clip with leads

    (3) 12" - 22 AWG solid core wire