LED Throwies

From MAKE Magazine

From MAKE Magazine

This project first appeared on the pages of MAKE magazine.

Add color to any ferromagnetic surface in your neighborhood.

  • Add Note x
  • x 7

Make and toss a bunch of these inexpensive little lights to add color to any ferromagnetic surface in your neighborhood.

Sections
Relevant parts
  • LED, 10mm diffused, any color(s) 20 cents each from HB Electronic Components (http://hebeiltd.com.cn).Buy it
  • Tape, strapping, 1" One roll will make many throwies.
  • Batteries, CR2032 3V lithium 25 cents each from CheapBatteries.com.Buy it
Relevant parts (continued)
  • Disc magnet, ½" to 1" diameter, NdFeB, Ni-Cu-Ni plated 25 count for about $15 from Amazing Magnets (http://amazingmagnets.com).
  • Epoxy, conductive, (optional) Weather-resistant alternative to tape. Available from Newark InOne (http://newark.com).Buy it
first image

Add Note Edit Step 1 — Test the LED.  ¶ 

  • Pinch the LED’s leads to the battery terminals, with the longer lead (the anode) touching the positive terminal (+) of the battery, and the shorter lead (the cathode) touching negative (-).

  • Confirm that the LED lights up.

  • Tape the LED leads to the battery by cutting off a 7" piece of strapping tape and wrapping it once around both sides of the battery. Keep the tape very tight as you wrap. The LED should not flicker.

  • Place the magnet on the positive terminal of the battery, and continue to wrap the tape tightly until it’s all done. The magnet should hold firmly to the battery.

  • The battery’s positive contact surface extends around the sides of the battery. Don’t let the LED’s cathode touch the positive terminal, or you’ll short the circuit.

  • That’s it — you’re ready to throw (or make a few dozen more). Throw it up high and in quantity to impress your friends and city officials.

first image

Add Note Edit Step 2  ¶ 

  • A throwie will shine for about 1-2 weeks, depending on the weather and the LED color. To get one off a ferro-magnetic surface, don’t pull it, or it may come apart. Instead, apply a lateral force to the magnet base, and slide it off the surface while lifting it with a fingernail or tool.

  • Throwies naturally chain together in your pocket, making multi-segmented throwie bugs, which will also stick to metal surfaces if they aren’t too long.

This project originally appeared in MAKE Volume 6, page 116.

For more information, check out the Circuits category page.

Did you successfully follow this guide?

This guide has been completed 7 times.

Comments Add Note Comments are onturn off

No comments.