Cute as a Button Bracelet

From CRAFT

From CRAFT

This project first appeared on the pages of CRAFT or on Craftzine.

Spotlight a handful of your favorite buttons with this easy project.

  • Author: Susan Beal
  • Time required: 30-45 minute
  • Difficulty: Easy
  • Add Note x

Spotlight a handful of your favorite buttons, vintage or new, with this easy project. Just thread them on wire to create a fun, instant-gratification bracelet!

Sections
Tools
Relevant parts
No image

Add Note Edit Step 1 — Design and thread.  ¶ 

  • Arrange your buttons in a row so that you like the mix of colors and sizes.

  • Slip the wire through one of the holes of your first button, back to front, and hold the button about 6" from one end of the wire. Feed the working wire through the opposite hole, pulling it taut so that the button “sits” where you’ve placed it. Repeat with the next button, securing it close to the first one. Add more buttons until your string of wired buttons is about 6" long.

first image

Add Note Edit Step 2 — Trim.  ¶ 

  • Clip the wire ends so they’re each 5"–6" long. Feed one of the ends back into the outermost hole of the last button, looping it through to reinforce it.

first image
thumb image 1
thumb image 2

Add Note Edit Step 3 — Loop.  ¶ 

  • Grasp the wire just above the button loop with your round-nose pliers, and make a neat 90° bend there. Adjust the round-nose pliers so they’re gripping to both sides of the wire bend, above and below it. Use flat-nose pliers to pull the wire tail over the end of the round-nose pliers and all the way around, creating a circle with a tail of wire still extending beyond it.

first image
thumb image 1
thumb image 2
thumb image 3

Add Note Edit Step 4 — Clasp.  ¶ 

  • Slip the clasp onto the loop and use flat-nose pliers to hold the circle while gripping the end of the wire tail with round-nose pliers.

  • Slowly wrap the wire tail around, working from top to bottom, creating a neat coil.

  • Clip the end of the wire flush with the coil, making sure the sharp tip isn’t sticking out — if it is, use flat-nose pliers to flatten and smooth it into the coil. Repeat on the other side to add the other half of the clasp.

This project first appeared in CRAFT Volume 07, page 38.

For more information, check out the Design category page.

Did you successfully follow this guide?

This guide has been completed 0 times.

Comments Add Note Comments are onturn off

No comments.